Winni V, also known as Winstrol, Winstrol Depot, or the chemical name stanozolol, is known in bodybuilding circles as one of the best ‘cutting’ steroid available. It is often used before a bodybuilding contest because there is no water retention, and it gives the muscles that ‘dry’, ‘hard’ look.  This is why bodybuilders are always looking to buy Winni V tablets.

Winni V, or Winstrol V, is actually the pill or tablet form of stanozolol, while Winstrol Depot is the liquid form.  A uniqe character of Winstrol Depot is that because the steroid is 17 alpha alkylated, the liquid can be consumed orally, rather than daily injections. However, some bodybuilders don’t believe that consuming the liquid orally is as effective as injecting on a daily basis.  That being said, the majority of bodybuilders choose drinking the liquid, rather than injecting ever day.

As for Winni V tablets, the pill/tablet form of Winstrol has been around for decades.  Back in the 90s, a common daily dosage of Winni V would be 16-24mgs per day.  The Winni pills were 2mgs each back then, so the user had to take quite a few a day. The 24mgs was considered a rather high dosage at the time. Fastforward to today, the minimum Winstrrol dosage you will see on steroid forums is 50mgs per day! That’s more than half the recommended dosage from just over ten years ago.

Winni V Cycles

Though it is possible, it is very rare for Winstrol to be used in bulking cycles.  Technically, any steroid can be used in bulking or cutting, but more often than not, Winni V is used in cutting cycle.

There are quite a few variations of Winni cycles a user may choose from.  Since winstrol can be taken in a pill form, it is commonly taken by bodybuilders who do not wish to take needles of other steroids, like testosterone, Deca Durabolin, etc.  However, most experienced steroid users will recommend that all steroid cycles start with a base steroid of testosterone. Whether it be testosterone propionate, testosterone cypionate, testosterone  enanthate, Omnadren, Sustanon 250, or any other form. Ideally, since Winni is used in cutting cycles, most people will recommend that Winstrol is stacked with testosterone propionate. They recommend propionate because like Winni, it offers minimal water retention, which all bodybuilders who are cutting, try to avoid.  A common basic steroid cycle with testosterone propionate and Winni would be:

Weeks 1-6

• Winstrol 50mgs per day
• Testosterone propionate 100mgs every other day.

Weeks 7-8 (or 10)

• Testosterone propionate 100mgs every other day.

After the cycle is completed, proper post cycle therapy is recommended.  The Winni V is only taken for 6 weeks because, as it is an oral 17AA steroid, it plays a toll on the kidneys and liver. If a user wanted to avoid needles, they could simply take the Winni V cyle alone, and not include any other steroids. Clenbuterol or Cytomel are other options that could be added for those looking to get lean.

If a user wanted to make their cycle more complicated, they could add a steroid like trenbolone acetate, Masteron, Primobolan, or various other steroids commonly used for cutting.  On top of that, the bodybuilder may also choose to run the Winni V towards the end of the cycle, ie weeks 2-8, so when they come off the testosterone propionate and Winstrol, they are at their ‘peak’.  A more complicated Winni cycle, using the previous technique, would look like the following:

Weeks 1-2

• Testosterone propionate 100mgs every other day.

Weeks 2-8

• Testosterone propionate 100mgs every other day.
• Trenbolone acetate 100mgs every other day.
• Winstrol 50mgs per day.

This is a very poplar cutting cycle, with what is considered to have relatively low dosages compared to today’s standards. Winstrol can have some side effects, please check Winni V side effects page for more detailed information on the side effects of Winstrol, or the following page for general steroids side effects.